Maintenance - ECM Manufacture MECHANIKA MAX Bedienungsanleitung

If you have set the cleaning mode, the 'CLn' on the display expires after the reset (see
Chapter 7.9). The counter will begin counting again until the next notice for cleaning the brew
head appears.
If you clean the brew group to often with cleaner, it may start squeaking. Don´t clean it to
often with cleaner, you will degrease all the moving parts and they will wear out quickly. It´s
better if you clean the brew group from time to time without cleaner.
10.3.

Maintenance

Caution!
Make sure that the machine is disconnected from the mains during maintenance and when
replacing individual parts.
Replacing the group gasket and the shower screen
1 Switch off the machine (power switch in position"0") and disconnect the power cord.
2 Let the machine cool down to room temperature.
Follow the steps as indicated below:
1
Brew group in the beginning.
4
Remove the shower screen and
the gasket completely.
Translation of the original German user manual
2
Use a flat screwdriver to pry out
the shower screen and the group
gasket.
5
Keep the new spare parts ready
at hand (the rounded side of the
group gasket with ECM print
faced upwards to the brewing
group).
3
The shower screen and the
gasket are now nearly removed.
6
Clean the group with a brush.
Lock the shower screen firmly
into the gasket.
ENGLISH
55