Machine In Use With Water Tank; First Use - ECM Manufacture MECHANIKA MAX Bedienungsanleitung

When using the machine with direct water supply, the valve has to be turned towards the water supply
adapter (image 1). The water supply adapter is located in the rear part of the bottom panel (image 1).
Additionally, place the switch behind the drip tray into position "1" (image 2).
Please make sure that your water tap is always open during water-connection usage so that the machine
does not run out of water!
Image 1 (Rear view)
Water connection nozzle
Important
• Do not leave the machine switched on or unattended when not in use.
• Make sure to close the shut off valve of the water connection and to switch off the
electric main switch or to disconnect the power plug when the machine is not in use.
• If you will not be using the machine for an extended period of time, we recommend
emptying the machine by flushing the water via the brew group. To refill, proceed as
described in the initial start-up (section 5).

4.3.2. Machine in use with water tank

When using the machine with a water tank, please turn the valve to the front side of the machine (image 3).
Additionally, select the "tAn" option to "on" (image 4).
Image 3 (Rear view)
Water connection nozzle
Important
• Please make sure that only a service agent or similarly qualified person connects the
machine to the water supply and installs the pressure regulator and shut off valve.
• To avoid calcification of the machine a water-softener is recommended.
• The machine may only be descaled by your service agent or similarly qualified person
because a partial disassembly of the boiler and the tubing may be necessary to prevent
the system from being blocked by lime residues. A late descaling can cause substantial
damage to the machine.
The residual water is disposed off periodically by emptying out the water drip tray.
Advice for machines with a fixed water connection:
The residual water is disposed off periodically by emptying out the water drip tray.

5. FIRST USE

Read the instruction manual carefully prior to operating the machine.
Prior to starting the machine, check if:
• the steam and hot water valves are closed.
• the machine is switched off. (Power switch in the vertical position.)
• the power cord is disconnected.
• the drip tray is inserted accurately.
• the machine is placed on a water resistant surface.
Translation of the original German user manual
Valve in permanent water
supply position (facing
toward the machine)
Valve in water tank
position (facing away
from the machine)
Image 2
Tank mode option "off"
Image 4
Tank mode option "on"
ENGLISH
37