Installing The Perimeter Wire - Stihl iMOW 5.0 Gebrauchsanleitung

English
a
► Route the perimeter wire (1) at least 37 cm
®
(length: 1x iMOW
plate (3) toward the side.
► Route the perimeter wire (1) at least a = 2 m
behind the base plate (3).
► Route the perimeter wire (1) in the center
behind the docking station toward the edge of
the mowing area.
Maintain the correct distance to the edge of
the mowing area depending on the adjacent
area.
► Route the perimeter wire (1) clockwise around
the mowing area,
66
1
3
Ruler) away from the base
8.

8 Installing the Perimeter Wire

8 Installing the Perimeter
Wire
8.1 General requirements
Checking routing of perimeter wire and guide
wire in the mowing area
b
1
a
2
► Make sure that the mowing area along the
perimeter wire and the guide wire is flat and
clear of obstacles as far as possible along the
following widths:
Perimeter wire (1)
– Toward the outside: a = 37 cm (length:
®
1x iMOW Ruler)
– Toward the inside: b = 1.2 m
Guide wire (2)
– Toward the right in the direction of travel
toward the docking station: a = 37 cm
(length: 1x iMOW
– Toward the left in the direction of travel
toward the docking station: c = 1.2 m
Installing the Perimeter Wire
► Install the perimeter wire clockwise starting at
the docking station.
► Do not kink, cut, put tension on or cross the
perimeter wire.
► Make sure that the perimeter wire does not
cross over a guide wire.
► Exception: When installing a corridor, the
guide wire must cross the perimeter wire.
► Keep a minimum distance of 1 m to perimeter
wires of adjacent robot mower installations.
► Make sure that the length of the perimeter wire
does not exceed 850 m.
c
®
Ruler)
0458-011-9801-A