Positioning The Docking Station; General Requirements - Stihl iMOW 5.0 Gebrauchsanleitung

English
► Transfer the information to your own garden:
– Outline of the mowing area
– Position of the docking station
– Routing of the perimeter wire (note descri‐
bed distances to the edges and wire routing
cases)
– Routing of the guide wire(s) (at least one,
maximum of two)
Preparing mowing areas
► Remove any objects lying around.
► Remove metals, magnetic materials and mate‐
rials that conduct electricity as well as old
perimeter wires.
► Mow lawns with a lawn mower to the cutting
height that will later be set for the operation of
the robot mower. The default setting for the
cutting height on the robot mower is a = 6 cm.
► Level out holes and rough, uneven patches.
► Where ground is hard and dry, slightly moisten
the mowing area to make driving the anchor‐
ing stakes easier.
► As a result of its design, the robot mower
leaves a strip with unmown lawn along unnavi‐
gable areas. This strip can be used, for exam‐
ple, to sow flower seeds and create areas with
blossoming vegetation for insects.
60
a
a

7 Positioning the docking station

► If you want to mow without leaving an edge
along inaccessible areas: Install edging stones
or flagstones with a minimum width of
a = 24 cm along these areas.
6.2 Preparing the robot mower for
operation
► Remove the packaging material and transport
locks.
► Ensure that the following components are in a
safe condition:
– Robot mower,
– Blades, 4.6.2
– Battery, 4.6.3
– Docking station and power supply,
► Positioning the docking station,
► Installing the perimeter wire,
► Completing the perimeter wire installation,
9.1
► Installing the guide wire,
► Electrically connecting the docking station,
11.1
► Charging the robot mower,
► Locking the Bluetooth
► If you cannot carry out these steps: Do not use
the robot mower and contact a STIHL author‐
ized dealer for assistance.
7 Positioning the docking
station
7.1

General requirements

WLAN
4.6.1
4.6.4
7
8
10.1
12.1
®
radio interface,
1
0458-011-9801-A
13.1