Routing The Perimeter Wire - Stihl RMI 632 Gebrauchsanleitung

Fix the docking station (B) into position at
the chosen location using four pegs (H).
● Install the power supply unit outside the
mowing area, protected from direct
sunlight, humidity and moisture – fasten
to a wall if necessary.
Correct operation of the power
supply unit is only ensured at an
ambient temperature between
0° C and 40° C.
● Route all power cables outside the
mowing area, in particular out of reach
of the mowing blade, and fasten them to
the ground or accommodate in a cable
duct.
● Unreel power cables in the vicinity of
the docking station in order to avoid
interference with the wire signal.
● Connect the mains plug.
The red LED on the docking station
flashes rapidly as long as no
perimeter wire is connected.
( 13.1)
0478 131 9954 A - EN
● After completing this installation
work, press the OK button on the
control panel.
With external docking station:
Define at least one starting point
outside the corridor to the docking
station after initial installation is
complete. Define the starting
frequency so that 0 of 10 mowing
operations (0/10) are started at the
docking station (starting point 0).
( 11.14)
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
Then press the OK button on the
control panel.
If the battery is discharged, a
plug symbol appears instead
of the battery symbol at the
top right corner of the display after
docking and the battery is charged
while the perimeter wire is being
routed. ( 15.8)

9.9 Routing the perimeter wire

Please read and observe the entire
"Perimeter wire" section before
performing wire routing. (
In particular, plan the routing,
observe the wire clearances and
install no-go areas, reserve wire,
linking sections, secondary
areas and corridors during wire
routing.
For smaller mowing areas with a wire
length of less than 80 m, the accessory
AKM 100 must be installed together with
the perimeter wire. If the wire lengths are
too short, the docking station flashes SOS
and no wire signal is output.
12.)
125