Handling; Cleaning And Servicing; Maintenance; Cleaning - Parkside PMNF 1500 A1 Originalbetriebsanleitung

2.­ To­turn­it­off,­release­the­on-off­button.­
The device turns off.
After switching on the device, wait until the
device has reached its max. speed. Only
then should you start with the work.
The disc still runs even after
the device has been switched
off. Risk of injury.
Trial run:
Always carry out a trial run before carry-
ing­out­your­first­grinding­procedure­and­
after every disc replacement. Switch the
device off immediately if the diamond
cutting disc is not rotating smoothly, if con-
siderable vibration occurs or if you hear
abnormal noises.

Handling

Using a line locator, check the
walls for hidden electricity
cabling and gas and water
pipes before working with
the wall chaser.
1. Switch on the wall chaser, position the
start­roller­(8)­against­the­wall­while­the­
cutting disks are rotating.
2. Bring the cutting disks into contact with
the wall.
3. The cutting direction should always be
opposite to the disks' rotational direc-
tion.­Check­the­marking­(13).­Pull the
machine towards you when working.
Otherwise, the wall chaser can be
pushed outside the cutting area in an
uncontrolled manner.
4. Once you reach the end of the groove,
remove the device from the groove be-
fore switching it off.
5. Chip out the resulting ridge between
the two grooves using the hand chisel
(11).

Cleaning and servicing

Pull the mains plug before any ad-
justments, maintenance or repair.

Maintenance

Have any work on the device
that is not described in this
instruction guide performed
by a professional. Only use
original parts. Allow the de-
vice to cool off before any
maintenance or cleaning is
undertaken. There is a risk of
burning!
Always check the device before using it for
obvious­deficiencies­such­as­loose,­worn­
or damaged parts, correct the positioning
of screws or other parts. Check the dia-
mond cutting disc in particular. Exchange­
the damaged parts.
If the replacement of the supply cord is
necessary, this has to be done by the
manufacturer or his agent in order to avoid
a safety hazard.

Cleaning

Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
GB
33