Parkside PMNF 1500 A1 Originalbetriebsanleitung Seite 28

GB
mensioned attachment tools can not be
adequately shielded or controlled.
g)­ The cutting disks and flanges
must fit the grinding spindle
precisely.­Disks­that­do­not­fit­the­
grinding spindle precisely rotate un-
evenly, vibrate sharply and can lead to
loss of control.
h)­ Never use damaged attachment
tools. Check attachment tools
such as grinding discs for chip-
ping or cracks, grinding plates
for cracks, wear or strong abra-
sion and wire brushes for loose
or broken wires before using
them. If the electric tool or the
attachment tool falls off, check
whether it is damaged or, use
an undamaged attachment tool.
If you have checked the at-
tachment tool and attached it,
keep yourself and any nearby
persons beyond the level of the
rotating attachment tool and al-
low the device to run for 1 min.
at the highest rotational speed.
Damaged tools usually break during
this test period.
i)­ Wear personal safety equip-
ment. Depending on the applica-
tion, use full face shields, eye
protection or safety goggles. In
so far as it is appropriate, wear
dust masks, ear protection,
gloves or special aprons which
keep small grinding and mate-
rial particles away from you.
Eyes­should­be­protected­from­the­
foreign matter which can be caused to
fly­during­the­various­applications.­Dust­
or­breathing­masks­should­filter­the­dust­
that is created during operation. If you
are exposed to loud noise for a long
time, you may suffer hearing loss.
28
j)­ Ensure that other people are at
a safe distance to your working
area. Anyone who enters the
working area should wear per-
sonal protective equipment. Bro-
ken bits from the piece being worked
or­broken­attachment­tools­can­fly­
away and cause injuries even beyond
the direct working area.
k)­ Hold the electric tool only by
the insulated gripping surfaces
when performing work in which
the cutting tool may come into
contact with hidden wiring or its
own cord. Contact with a live wire
can also cause a charge in metal parts
of the device and result in an electric
shock.
l)­ Keep the cord away from the
rotating attachment tool. If you
lose control of the device, the power
cord can become separated or caught
and your hand or arm may be pulled
into the rotating attachment tool.
m)­ Never put the electric tool down
before the attachment tool has
come to a full stop. The rotating
attachment tool can come into contact
with the surface upon which it is set,
whereby you could lose control of the
electric tool.
n)­ Never allow the electric tool to
run while you are carrying it.
Your clothing may accidentally come
into contact with the rotating attach-
ment tool and get caught and the
attachment tool could drill into your
body.
o)­ Clean the ventilation slots of
your electric tool routinely. The
motor air pulls dust into the housing
and, should too much metallic dust col-
lect, could cause electrical hazards.