Stability Of Planting Unit And Tractor During Transport; Preparations For Sowing; Speed Change Gear - Gaspardo NINA Gebrauch Und Wartung

ENGLISH
3.3 STABILITY OF PLANTING UNIT AND TRACTOR
DURING TRANSPORT
When a planting unit is coupled to a tractor, so becoming an
integral part of it for the purposes of road travel, the stability of the
planting unit-tractor complex may change and cause driving or
operating difficulties (rearing up or side-slipping of the tractor).
The condition of equilibrium can be restored by placing a sufficient
number of ballasts on the front of the tractor so that the weights
on the two tractor axles are distributed sufficiently evenly.
To work in safety the instructions given in the highway code should
be followed; these prescribe that at least 20% of the weight of the
tractor alone should be borne by the front axle and that the weight
on the arms of the hoist should not be more than 30% of the
weight of the tractor itself. These factors are summarized in the
following formulas:
Z > [M x (s1+s2)]-(0.2 x T x i)
The symbols have the following meanings (please see Fig. 9 for
reference):
M (Kg) Mass weighing on arms off hoist with full load (weight +
mass, see cap. 1.4 Identification).
T (Kg) Mass of tractor.
Z (Kg) Total mass of ballast.
i (m) Tractor wheelbase, that is, the horizontal distance
between the tractor axles.
d (m) Horizontal distance between the centre of gravity of the
ballast and the front axle of the tractor.
s1 (m) Horizontal distance between the inferior point of
attachment of the equipment and the posterior axle of
the tractor (equipment supported to the ground).
s2 (m) Horizontal distance between the barycentre of the
equipment and the inferior point of attachment of the
equipment (equipment supported to the ground).
The amount of ballast that should be applied according to the
formula is the minimum required for circulation on the road. If for
reasons of tractor performance or to improve the set-up of the
planting unit during operation it is thought necessary to raise
these values, please refer to the registration document of the
tractor to check its limits.
When the formula for calculating the ballast gives a negative
result it will not be necessary to add any weight. In any case, as
long as the limits of the tractor are respected, a suitable quantity
of weights may be applied in order to ensure greater stability
during travel. Check that the tractor tyres are suitable for the load.

3.4 PREPARATIONS FOR SOWING

To obtain the most correct investment of the seeds per hectare
(kg/Ha) the distribution parts must be adjusted properly: the gear-
box, the feelers, rollers and sliding doors. Use the sowing table
to find the relevant instructions (refer to the sowing test chapter
3.11.5). To proceed, the values to follow are: the type of seed
(wheat, barley, etc.), the amount in kg to be distributed per hectare
and the distance between the rows to be sowed.

3.4.1 SPEED CHANGE GEAR

The gear shift is located on the right side of the seeder and
receives motion from the drive wheel. The gear shift is used to
change speed to the seed distribution units through the
adjustment lever which is calibrated on a continuous scale of 1
to 55 (Fig. 10).
Loosen the knob, move the lever to bottom of scale «0» (zero)
and then set it to the value indicated. Lock it by tightening the
knob.
36
USE AND MAINTENANCE
(d+i)
g
fig. 9
fig. 10
1
S2 = 380 mm
55
cod. G19502553