Technical Data - Bosch GTM 12 JL Professional Originalbetriebsanleitung

(6) Tilt protector
(7) Saw blade
(8) Dust bag
(9) Chip ejector
(10) Bracket locking screw (11)
(11) Bracket
(12) Hex socket screw for mounting the saw blade
(13) Spindle lock
(14) Clamping flange
(15) Inner clamping flange
(16) Laser lens cap
Mitre Saw Components
(17) Button to unlock the tool arm
(18) Handle
(19) Laser unit/laser radiation outlet
(20) Retracting blade guard
(21) Screw clamp
(22) Saw table for the mitre saw
(23) Scale for mitre angles
(24) Insert plate
(25) Locking knob for all mitre angles
(26) Mitre pre-setting lever
(27) Detents for standard mitre angles
(28) Holes for screw clamp
(29) Saw table extension
(30) Fence
(31) Adjustable fence
(32) Stop screw for 33.9° bevel angle
(33) Stop pin for 33.9° bevel angle
(34) Lighting unit
(35) Switch for lighting unit ("Light")
(36) Switch for marking of cutting line ("Laser")
(37) Clamping handle for various bevel angles
(38) Transport safety lock
(39) Hex socket screw (6 mm) for fence
(40) Laser warning label
(41) Hex socket screw for saw table extension
(42) Threaded rod
(43) Wing bolt
(44) Locking screw for the adjustable fence

Technical Data

Combination saw
Article number
Rated power input
No-load speed
Bosch Power Tools
(45) Locking clamp
(46) Fine scale
(47) Angle indicator (vertical)
(48) Scale for bevel angles
(49) Screws for insert plate
(50) Rubber cup (front)
(51) Set screw for laser positioning (parallelism)
(52) Set screw for laser positioning (flush levelling)
(53) Rubber cap (side)
(54) Set screw for laser positioning (lateral deviation)
(55) Fine scale screw
(56) Screw for bevel angle indicator
(57) Hex socket screw (3 mm) for standard bevel angle
0°
(58) Hex socket screw (3 mm) for standard bevel angle
45°
Table Saw Components
(59) Table saw table
(60) Riving knife
(61) Parallel guide
(62) Push stick
(63) Protective guard
(64) Clamping handle for parallel guide
(65) Scale for spacing between saw blade and parallel
guide
(66) Lower saw blade cover
(67) Pins for fixing the push stick
(68) Clamping lever
(69) Spacing indicator
(70) Screw for parallel guide spacing indicator
(71) Guide for parallel guide
(72) Adjusting screw for adjusting the clamping force of
the guide (71)
(73) Screw for the parallel guide guide rails
(74) Set screw for the parallel guide
Length stop
(75) Clamping screw for length stop
(76) Holes for length stop
a)
(77) Length stop
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GTM 12 JL
3 601 M15 0..
W 1800
–1
min 3800
English | 39
GTM 12 JL
3 601 M15 061
1650
3700
1 609 92A 7SS | (06.03.2023)