Connection To Water Supply; Connection, Electrical; Accutom-2; Recirculating Cooling Unit - struers Accutom-2 Gebrauchsanweisung

Connection to water supply

Connection, electrical

Accutom-2

Recirculating cooling unit

Stand for rotating/swivelling
specimen holder (CATAS)
12
Accutom-2
Instruction Manual
Dismount the L-tube section which is meant for use together with the
recirculating cooling unit.
Place the pressure reducing section in the pipe branch and mount it on
the inlet valve of Accutom-2 instead of the L-tube section (also see
fig. 3).
Place a 13 mm tube clip on the reinforced PVC-tube and place the tube
on the tube branch. Tighten the tube clip so that the joint becomes tight.
Place the other end of the hose on the water tap in a similar way. If
necessary, shorten the hose.
Always turn off the water supply at the water tap
Before connecting the apparatus check that the operating voltage
of the apparatus corresponds to the mains voltage.
The operating voltage is indicated on the tag at the mains voltage cable.
Mount a plug on the mains cable:
Yellow/green: earth
Blue: neutral
Brown: phase
(blue and brown lead are freely interchangeable).
or Green: earth
Black: neutral
White: phase
(Black and white lead are freely interchangeable).
The recirculating cooling unit is meant for use together with Accutom-2 and
will be supplied from there. The connection takes place by connecting the
plug of the pump on the rear side of Accutom-2.
Mount a plug on the mains cable:
Yellow/green: earth
Blue: neutral
Brown: phase
(blue and brown lead are freely interchangeable).
or Green: earth
Black: neutral
White: phase
(Black and white lead are freely interchangeable).
IMPORTANT
when Accutom-2 is not in use.
IMPORTANT