Electrical Connection; Transport; Cleaning, Maintenance And Ordering Spare Parts; Exterior Cleaning - Scheppach DECO FLEX SL Original Bedienungsanleitung

• Hold the flexible shaft by the handle and adjust the
speed control as described under (9.2 / 9.9).
• After finishing the work, remove the flexible shaft
again and unscrew the protective cover (38) again.
• Attention: When working with the flexible shaft,
cover the saw blade with the blade guard (5).
9.8 ON/OFF switch (15) (Fig. 2)
• Switching on: Press the green "I" button.
• Switching off: Press the red "0" button.
ATTENTION
The machine is equipped with a safety switch against
reactivation if the voltage drops.
If the scroll saw is switched on and the power supply in
the mains is interrupted, the scroll saw remains switched
off, even if the power supply is re-established. Press the
"I" button to switch it on.

10. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions.
The customer's mains connection as well as the
extension cable used must also comply with these
regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors
• Kinks where the connection cable has been improp-
erly fastened or routed
• Places where the connection cables have been cut
due to being driven over
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions.
Only use connection cables with the marking H 05 VV-F.
The printing of the type designation on the connection
cable is mandatory.
AC motor
• The mains voltage must be 220-240 V~.
• Extension cables up to 25 m long must have a
cross-section of 1.5 square millimetres.
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Data of machine type plate

11. Transport

• Transport the electric tool by lifting it by the machine
housing (36). (Fig. 26)
• Never use the protective devices for handling or
transport.
• Make sure that the exposed part of the saw blade
is covered during transport, e.g. by the protective
device.
12. Cleaning, maintenance and
ordering spare parts
WARNING
Always switch the machine off and remove the mains plug
prior to all maintenance and cleaning work.
12.1 Cleaning
Keep protective devices, air vents and the motor hous-
ing as free of dust and dirt as possible. We recommend
cleaning the device directly after every use.

12.1.1 Exterior cleaning

• Clean the device at regular intervals using a damp
cloth and a little soft soap.
• Do not use cleaning agents or solvents. These could
damage the plastic parts of the device.
• Make sure that no water can penetrate the device
interior.
12.1.2 Interior cleaning (fig. 15)
1. Remove the screw (33).
2. Loosen the screw (32).
3. Remove the cover (7).
www.scheppach.com GB | 37