GF UD2100 Betriebsanleitung Seite 16

UD2100 Ultrasonic Doppler Flow Meter
-- Units / Mode ----------
Mode
Linear
Volume
Multiplier
Decimals
Velocity
Flow
Decimals
-- Units/Mode --------
Mode
Linear
Volume
Multiplier
Decimals
Velocity
Flow
Decimals
16
Units/Mode
Flow
At Mode, press the
in
USG
the flow rate in engineering units (e.g. gpm, litres/sec, etc.) Press the
x1
tion then the
0
ft/s
USG/m
At Linear press the
2
Linear units define what units the pipe dimensions and sensor spacing will be displayed in.
Typically inches or mm is selected. Press the
menu item.
At Volume, press the
US oil barrels. Press the
At Multiplier, press the
are used when resolution down to single digit is not required, or when you don't want to con-
vert from gallons to thousands of gallons, as an example. Press
then to the next menu item.
At Decimals (Volume), press the
points to be present on the totalizer display on the LCD screen. Default = 0. Options = 0, 1, 2.
Press the to store your selection then the
At Velocity, press the
ity. Press to store your selection then
Units/Mode (cont.)
Flow
At Flow, press the
in
USG
flow rate. Press
x1
0
ft/s
USG/m
2
and then the or
to the next menu item.
key and then the
and then the or
to store your selection then the
and then the
and then the
and then the or
and then the or
to store your selection then
to select Flow or Velocity. Flow mode displays
or to select your units of measurement. The
to store your selection then the
to select units for volume. Note: "bbl" denotes
to the next menu item.
or to select the totalizer multiplier. Multipliers
to store your selection
or to select the number of decimal
to the next menu item.
to select the engineering units for flow veloc-
to the next menu item.
to select the engineering units for
to the next menu item.
Operating Instructions
to store your selec-
to the next