Safety Check; Personal Protective Equipment; For Your Own Safety During Operation - Optimum OPTigrind GU 30 Betriebsanleitung

1.9

Safety check

Check the grinding machine regularly.
Check all safety devices

before starting work,

once a week (with the machine in operation) and

after all maintenance and repair work.
1.10

Personal protective equipment

For certain work personal protective equipment is required.

Protect your face and your eyes: Wear a safety helmet with facial protection when perform-
ing work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces with sharp edges.

Use safety shoes when you assemble, disassemble or transport heavy components, or
transport the grinding machine.

Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).

Before starting work make sure that the required personal protective equipment is available
at the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
1.11

For your own safety during operation

WARNING!
Before switching the grinding machine on, make sure that there is no risk of personal
injury or damage to property.
Avoid any unsafe work methods:

The instructions mentioned in these operating instructions have to be strictly observed dur-
ing assembly, operation, maintenance and repair.

Use protective glasses!

Do not work on the grinding machine, if your concentration is reduced, for example,
because you are taking medication.

Stay on the grinding machine until the working spindle has come to a complete standstill.

Use the specified personal protective equipment. Ensure you wear close-fitting clothing
and, if necessary, a hairnet.

Make sure that your operation does not create a safety hazard.
1.12 Disconnecting and securing the grinding machine
Disconnect the mains plug before starting maintenance and repairs.
1.13 Emissions
The noise generation (emission) of the grinding machine is 74 to 77 dB (A). The sound power
level is 82 to 85 dB (A). If the grinding machine is installed in an area where various machines
are in operation, the noise exposure (immission) on the operator of the grinding machine at the
working place may exceed 80 dB(A).
INFORMATION
This numerical value was measured on a new machine under the operating conditions specified
by the manufacturer. The noise behaviour of the machine might change depending on the age
and wear of the machine.
GB GU30
26 Translation of original instruction
Safety
Version 1.0.2 - 2021-3-9