Reasonably Foreseeable Misuse; Avoiding Misuse - Optimum OPTigrind GU 30 Betriebsanleitung

WARNING!
Extremely severe injuries due to non-intended use.
It is forbidden to make any modifications or alternations to the operating parameters
values of the grinding machine. They could pose an accident hazard to persons and
cause damage to the grinding machine.
ATTENTION!
If the grinding machine is not used as intended or if the safety directives or the operating
instructions are ignored the liability of the manufacturer for any damages to personnel
or objects resulting hereof is excluded and the claim under guarantee is becoming null
and void!
1.3

Reasonably foreseeable misuse

Any other use other than that specified under "Intended use" or any use beyond the described
use shall be deemed as non-intended use and is not permissible.
Any other use has to be discussed with the manufacturer.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning.
Operators must be qualified.
1.3.1

Avoiding misuse


The distance from the supporting surface to the grinding wheel may not be less than 2 mm.
However, the distance may be greater if the grinding process and the material used require
this for security reasons.
We expressly point out that the guarantee will expire, if any constructive, technical or proce-
dural changes are not performed by the company Optimum Maschinen Germany GmbH.
WARNING!
Risk of injury caused by flying workpieces.
Ensure the gap between the grinding wheel and bearing surface is as small as possible and
readjust the support surface immediately if the distance is too big.
If the support surface can no longer be adjusted, the grinding wheel must be replaced.
1.4 Possible dangers caused by the grinding machine
The grinding machine was built using state-of-the-art technology. Nevertheless, there is a resid-
ual risk, as the grinding machine operates with

high speeds,

rotating parts,

with grinding wheels (emission of sparks),

electrical voltage and currents.
We have used design and safety engineering to minimize the health risk to personnel resulting
from these hazards.
If the grinding machine is used and maintained by personnel who are not duly qualified, there
may be a risk resulting from its incorrect or unsuitable maintenance.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

and strictly follow these operating instructions.
Safety
Version 1.0.2 - 2021-3-9 Translation of original instruction
GU30 GB
23