Have You Understood Everything; Preparing For Use; Vacuum Dust Extraction; Adapter For External Vacuum Extraction (With Reducer Piece) - Parkside PDS 290 A1 Bedienungs- Und Sicherheitshinweise

A void sanding paints containing lead or other
substances hazardous to health.
D o not work on materials containing asbestos.
Asbestos is a known carcinogen.
A void contact with the moving sanding sheet.
O perate the device only with an attached
sanding sheet.
N ever use the device for a purpose for which it
was not intended nor with non-original parts /
accessories. The use of tools or accessories other
than those recommended in the operating in-
structions could lead to you suffering an injury.
S witch the device off and allow it to come to a
standstill before you put it down.
A lways keep the device clean, dry and free of
oil or grease.
Have you understood
Q
everything?
O nce you have made yourself familiar with the
instructions and advice, the functioning and
handling of your device, you are finally in a
position to start work. Observing the manufac-
turer's instructions and advice will maximise
your safety while working with the device.

Preparing for use

Q
CAUTIoN! Make sure that the device is switched
off before you connect it to the mains supply.
Note: Always switch on the delta sander before
bringing it into contact with the workpiece material.
Switching on the device:
M ove the ON / OFF switch
setting "I".
Switching off the device:
M ove the ON / OFF switch
setting "0".
Selecting the oscillation speed:
You can preselect the oscillation speed you require
using the oscillation speed setting wheel
can also change the speed whilst you are working.
General power tool safety warnings / Preparing for use
The way to determine the optimum oscillation
speed for your task is to carry out a practical test.
Setting 1 = lowest oscillation speed /
Setting max. = highest oscillation speed
Q
the danger of fire when working with electrical
devices that have a dust box or can be connected
to a vacuum cleaner. Under certain conditions the
wood dust in the dust extraction bag (or in the vac-
uum's dust bag) may ignite, e.g. as a result of flying
sparks generated when abrading metals or metal
objects left in wood. This can happen particularly if
the wood dust is mixed with paint residue or other
chemicals and the abraded particles are hot from
prolonged abrasion. Therefore you must empty the
device's dust collection box and the vacuum clean-
er's dust bag before taking a break or stopping work
and always avoid overheating of the abraded par-
ticles and the device.
Wear a dust mask!
out of the socket before doing any work on the
device.
Q
Connection:
forwards into
1
backwards into
1
. You
2

Vacuum dust extraction

DANGER oF FIRE! There is
Always pull the mains plug is
Adapter for external vacuum
extraction (with reducer piece)
P ush the adapter for external vacuum extrac-
tion into the dust extraction spout
7
When doing this observe the guide markings
on the device and adapter. Turn the suction
nozzles clockwise to lock.
I f it is necessary to use the reducer piece
push the reducer piece into the adapter for
external vacuum extraction
P ush the hose of a suitable dust extraction de
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction or the reducer piece
7
.
4
,
8
.
7
.
8
GB/MT 35