Adapter For External Vacuum Extraction (With Reducer Piece); Rotating The Backing Plate; Advice On Use; Maintenance And Cleaning - Parkside PAHS 12 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Adapter for external vacuum
Q
extraction (with reducer piece)
Connection:
P ush the adapter for external vacuum extraction
into the adapter connection
4
I f it is necessary to use the reducer piece
push the reducer piece into the adapter for
external vacuum extraction
P ush the hose of a suitable dust extraction de
vice approved for that purpose (e.g. a work-
shop vacuum cleaner) on to the adapter for
external vacuum extraction
piece
4a
Removal:
P ull the hose of the dust extraction device off
the adapter for external vacuum extraction
P ull off the adapter for external vacuum extrac-
tion
4
Attaching / detaching
Q
sanding sheets
Attaching:
S anding sheets are attached to the backing plate
by means of the hook and pile fastening.
8
Detaching:
S imply pull the sanding sheet off the backing
plate
8

Rotating the backing plate

Q
R otate the backing plate
position (see Fig. D).
Sanding and surfaces:
The sanding output and the quality of the surface
finish are determined by the grade of grit on the
sanding sheet.
A lways use sanding sheets with grades that
are suitable for the particular surface you are
sanding.
Downloaded from www.Manualslib.com
Start-up / Maintenance and cleaning / Service centre
3
.
4
or the reducer
4
.
(with the reducer piece
4a
(see Fig. C).
into the desired
8
manuals search engine

Advice on use

Q
S witch the device on before placing it against
the workpiece.
A pply light sanding pressure only.
. A dvance the device at an even rate.
, C hange sanding sheets at the appropriate time.
4a
D o not work on different types of material using
the same sanding sheet (e.g. wood and then
metal).
C lean the sanding sheet from time to time with
a vacuum cleaner.
S and difficult to reach places with the front or
side corners of the backing plate

Maintenance and cleaning

Q
.
4
if used). of the socket before doing any work on the device.
The battery powered palm sander is maintenance-free.
F or cleaning the housing use a dry cloth only.
R emove any adhering sanding dust with a
narrow paint brush.
N ever any kind of sharp object or petrol,
solvents or cleaning agents that might attack
plastic. Do not allow any liquids to enter the
inside of the device.
A lways keep the ventilation slots

Service centre

Q
repaired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
lead needs to be replaced, always
have the replacement carried out by
the manufacturer or its service centre.
This will ensure that your device remains safe
to use.
.
8
Always pull the mains plug is out
clear.
7
Have your device
If the plug or mains
GB/IE 11