NOTE
Some materials may be damaged by exposure to heat . Test on scrap
u
material .
Remove any glue residue after it has cooled down with a sharp knife .
u
Bonded joints can be released by heating .
Large areas are difficult to bond . The adhesive will harden before you have
u
extruded the right amount .
Switching off
Switching off the product: Press the on/off button
indicator
and the LED work light
[
8 ]
During breaks in work, keep the product in standing position so that the
product is standing on its base
Before storing the product: Allow the product to cool down fully .
WARNING!
m
The hot nozzle
u
Automatic switch off
NOTE
The product switches itself off after approx . 10 minutes to save energy .
u
To save energy, do not switch on the product unless you plan to use it .
u
.
6 ]
[
can cause damage and/or burns .
1 ]
[
. The battery status
7 ]
[
switch off .
9 ]
[
GB
23