Preparing The Surfaces To Be Glued; Switching The Appliance Off; Maintenance And Cleaning - Parkside PNKP 105 B1 Originalbetriebsanleitung

Preparing the surfaces to be glued:

♦ Pull the trigger
with your requirements .
1 . Apply the glue in spots . For flexible materials, such as textiles,
apply the glue in zigzag lines .
2 . Press the two workpieces to be bonded together immediately
after applying the glue and hold for about 30 seconds . The
glued bond is ready after about 5 minutes .
3 . During breaks in work, put the glue gun down on the stand

Switching the appliance off:

♦ Unplug the appliance from the mains socket .
The nozzle
140

Maintenance and cleaning

WARNING! ALWAYS REMOVE THE POWER PLUG
FROM THE POWER SOCKET BEFORE CLEANING
THE APPLIANCE .
■ The low-temperature glue gun is maintenance-free .
■ Keep the appliance clean and dry at all times .
■ Never permit liquids to enter inside the appliance . Use a cloth to
clean the housing . Never use petrol, solvents or cleansers which
can damage plastic .
PNKP 105 B1
to regulate the flow of glue in accordance
reaches a temperature of over 140°C .
.
GB │ IE │ 21 ■