Gluing - Parkside PHPA 4 C4 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

˜ Gluing
m WARNING!
If hot glue comes into contact with skin, a serious burn may occur . Run under
u
cold water for several minutes and seek medical attention if required .
Residual glue may result in dripping . Ensure that work surface is suitably
u
protected from dripping glue .
Avoid contact with the hot nozzle
u
Wear heat resistant gloves when using this product .
u
Place the nozzle
Pull the trigger
nozzle . Release the trigger to stop the glue flow .
Apply the glue in spots . For flexible materials, such as textiles, apply the glue in
zigzag lines .
Press the two workpieces to be bonded together immediately after applying
the glue . Hold for approx . 30 seconds . The glued bond is ready after approx .
5 minutes .
Insert a new glue stick
totally drawn into the feeder shaft .
During breaks in work, keep the product in standing position so that the
product is standing on its base
22 GB
close to the work surface .
1 ] [
slowly, until the melted material begins to flow from the
10 ] [
into the feeder shaft
4 ] [
6 ] [
.
1 ] [
, when the old glue stick is
3 ] [
.