Initial Start-Up; Inserting The Glue Stick; Removing/Inserting The Rechargeable Battery; Switching On And Off - Parkside PHPA 20-Li A1 Originalbetriebsanleitung

6) SERVICE
a) have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
b) Never repair damaged batter-
ies. All battery repairs should be car-
ried out by the manufacturer or author-
ised customer service centres only.
7) SPECIFIC SAFETy INSTRUCTIONS
FOR hOT GLUE GUNS
• Children should be supervised
to ensure that they do not play
with the device.
• CAUTION! This device must be
placed on its inserted battery
when it is not in use
• Allow the device to cool down
completely before putting it away.
• Do not use any materials con-
taining asbestos.
• Avoid risks of injury and fire
as well as any health hazards:
Risk of burn injury!
The nozzle heats up to up to 180°C.
The glue heats up to up to 180°C.
Do not touch the nozzle or the glue.
Do not get any hot glue on people or
animals.
I n case of contact with the skin, imme-
diately hold the burn site under cold
running water for several minutes. Do
not attempt to remove the glue from
the skin.
• Do not attempt to pull the glue stick
back out of the device.
• Do not use any accessories
that are not recommended by
PARKSIDE. This can result in electric
shock or fire.
Observe the safety informa-
tion and notes on charging
and proper use as shown in
the instruction manual for
your battery and charger
from the Parkside X 20 V
Team series. A detailed de-
scription of the charging pro-
cess and further information
can be found in the separate
operating instructions.

Initial start-up

Inserting the glue stick

From the back, insert a glue stick (2) into
the inlet channel (3) on the gun pushing it
as far as it will go. Make sure by pressing
the trigger (7) that the glue stick is in direct
contact with the heating element.
Removing/inserting the rechar-
geable battery
1. To remove the rechargeable battery
( 4) from the device, press the re-
A
lease button (
pull the battery out.
2. To insert the battery (
tery along the guide rail into the device.
You will hear it click into place.

Switching on and off

Switching the device on::
Hold down the transparent On/off switch
( 1) for 3 seconds.
A
The LED work light (
permanently.
Switching off the LED work light:
The device is switched on, the LED work
light lights up permanently. To switch off
GB
5) on the battery and
A
4), push the bat-
A
6) now lights up
A
IE
21