VOLTCRAFT VC33 Bedienungsanleitung Seite 51

1. Disconnect the component you want to measure from the power supply and
completely discharge it.
2. Press the power button to switch the multimeter on.
3. (If not using SMART mode) Repeatedly press the button FUNC until the display
shows the continuity symbol
4. Connect the red test lead to the measurement socket INPUT.
5. Connect the black test lead to the measurement socket COM.
6. Connect the test probes to each other to check for continuity.
à
The display should show 0 – 0.5 Ω (inherent resistance of the test leads).
7. Connect the two test probes to the component that you want test.
à
Beeps will sound if the resistance is below or equal to 50 Ω
à
The display shows the measured value.
à
The display shows "OL" if the measured value exceeds the max. permiss-
ible value or if the circuit is broken (open).
8. Remove the test probes from the measured object.
.
51