4.9.2 Position change of the V-belt package
Opening the protective cover
Turn the machine off at the main switch.
Disassemble two thumbscrews
gear.
1
2
Loosen the two fastening screws, the one on the right and the other on the left of the
engine.
Img.4-1:
Fastening screws
Release the V-belts by pushing the engine up.
Put the V-belts on the other V-belt pulleys.
Retighten the V-belts by pushing the engine down.
Retighten the fastening screws.
ATTENTION!
Watch for the proper tension of V-belts.
INFORMATION
The V-belts are having the right tension if you can press into each one of them about 5mm with
your finger.
EN
TH3309 | TH3309D
106
and
and open the protective cover of change
1
2
Fastening screw on the right
Translation of original instruction
Version 1.1.0 - 2020-08-06