Lathe Spindle Fixture - Optimum OPTiturn TH 3309 Betriebsanleitung

4.13

Lathe spindle fixture

11
40
DIN ISO 702-2 Nr. 4 (Camlock)
WARNING!
Do not clamp any workpieces that exceed the permitted chucking capacity of the lathe
chuck. The clamping force of the chuck is too low if its capacity is being exceeded. The
clamping jaws may loosen.
Only use lathe chucks designed for the speed of the machine.
Do not use lathe chucks with an external diameter that is too large.
Please ensure that lathe chucks are manufactured to EN 1550 standards.
The spindle nose is designed as a Camlock 4 DIN ISO 702-2 holding fixture.
CAUTION!
Regularly check the closed status of the clamp bolt.
INFORMATION
Mark each workpiece holder for instance by a nick in order to facilitate the recover of the preci-
sion of the concentric run and the axial run-out deviation.
TH3309 | TH3309D EN
Version 1.1.0 - 2020-08-06 Translation of original instruction 109