Removing And Cleaning The Wire Guides - Atag CX4771B Gebrauchsanweisung

Removing and cleaning the wire guides

WARNING!
After cleaning, re-tighten the screws on the guides with a screwdriver.
When replacing the wire guides, make sure you mount them on the same side they were
installed on prior to removal.
Cleaning and maintenance
1 Undo the screw. Use a screwdriver.
2 Remove the guides from the holes in the
back wall.
INFORMATION!
Take care not to lose the spacers fitted on
the wire guides. Replace the spacers after
cleaning; otherwise, sparks may appear.
41