Choosing The General Settings - Atag CX4771B Gebrauchsanweisung

Press and hold the
settings menu will appear.
INFORMATION!
Rotate the KNOB to scroll through the settings. Confirm each setting by pressing the KNOB or
the key.

Choosing the general settings

key. SEtt will appear on the display unit for a few seconds. Then, the general
Clock display
Rotate the KNOB to set the clock. CLoc will appear on the display unit.
After confirming, you can choose between the 12h and 24h clock
display. Confirm, then set the clock/time of day. First, set the minutes.
Confirm, and then set the hours and confirm again.
Acoustic signal volume
Choose between three acoustic signal volume levels. Rotate the KNOB
to choose the VoL setting. Confirm the setting and set the volume. There
are four available volume levels (zero bars
bars).
Display illumination
Choose between three levels of display light intensity. Rotate the KNOB
to select the brht setting. Confirm your selection and choose lower or
higher intensity. There are three available illumination levels (one, two
or three bars).
Display unit night mode
This function will automatically dim the display (switch from high to low
display illumination level) during night time (8:00 p.m. to 6:00 a.m.).
Choose the nGht setting. Rotate the KNOB to switch On or OFF.
Standby
This function switches the clock display on or off. Select the hidE
setting. Rotate the KNOB to switch On or OFF.
Adaptive function
The function allows adjusting the set cooking temperature and the
cooking time. As a factory default, this function is deactivated, but you
can activate it.
When the function is activated, the most recent cooking time is
displayed. Settings for the most recent cooking session lasting at least
1 minute are taken into account.
AdPt will appear on the display unit. To deactivate the function, rotate
the KNOB to position OFF. Follow the same procedure to activate the
function. Select "On" on the display unit.
OFF, one, two or three
31