Herunterladen Inhalt Inhalt Diese Seite drucken

Specification - Wohler DC 100PRO Bedienungsanleitung

Druckcomputer version 6 mit 4-pa-test und ventilationsverlustmessung
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. Specification

1. Specification
1.1 Important Information
Before using this instrument, carefully read and observe all notes contained in
these operating instructions.
Fundamentally, skilled personnel only should use the Wöhler DC 100
the purpose that it is intended and within the specified data range. No liability
is accepted under any circumstances or guarantee given for results deter-
mined in conjunction with this instrument nor for any damage that may arise
when using this instrument.
1.2 Applications
The Pressure Computer DC 100
ter for registering differential pressures, temperatures, and humidities. The
extreme precision of this device not only registers minimum pressures in the
0.01 Pa range for flow rate and gas pressure measurements, but also deter-
mines volumes for measuring draughts with the simultaneous registration of
exhaust gas temperatures. A maximum measuring range of 100 hPa and a
rupture pressure of 0.75 bar also provide for adequate safety at higher pres-
sure ranges. During all measurements the user is guided by plaintext instruc-
tions on the display. The new high-precision pressure measurements of 0.01
Pa now also allows measurements of flow speeds in the 0.1 m/s range.
Thanks to its high measuring accuracy, the Wöhler DC100
following measurement tasks:
1. Detection and inspection of low pressures in a closed air loop with simulta-
neous operation of a combustion installation and an exhaust-gas system.
The optionally available Woehler 4 Pa Set contains specific flexible capilla-
ry tubes for this purpose (see chapter 3.1).
2. A highly sensitive S-type Prandtl tube connected to the DC 100
to evaluate the ventilation loss of boilers during the evaluation of the ener-
gy efficiency according to article 8 of the European Building Performance
Directive (EBPD; see chapter 4).
3. The DC 100
PRO
room (e. g. a tank, a bottle or a pipe). A defined sample volume is taken
from the room. Then the total volume is calculated using the pressure
change resulting from this (see chapter 5).
44
Hotline: +49 2953 73-211
PRO
also allows to determine the volume of a closed and airtight
is a high-precision multifunctional me-
Fax: +49 2953 73-250
Wöhler DC 100
for
PRO
is ideal for the
PRO
permits
PRO
PRO

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis