Controls And Connections - Wohler DC 100PRO Bedienungsanleitung

2. Controls and connections

2. Controls and connections
Figure 2.1 below shows the indicators and controls on the DC 100
display always shows the trend ▲▼ on the left, the numerical value in the
middle, and the corresponding unit of measurement on the right. When a
key is pressed, a cursor ▲ appears in addition at the edge of the display to
mark the menu near the display label. This menu is activated when the cursor
flashes.
The functions assigned to the keys resemble those on a mobile phone. In
general, the ± key on the left increments or decrements an entered value or
displaces to the left or right the cursor ▲ at the edge of the display (see Fi-
gure). A short double tap on the ± key switches from increment to decrement
mode or reverses the cursor's movements.
1
2
3
Figre 2.1: Display and controls on the DC 100
This toggle function is indicated by a dot at the centre of the display. A se-
cond double tap switches back to increment mode or restores the cursor's
original direction.
Example: Pressing the ± key moves the cursor from its position "Signal" in
Figure 2.1 to "Q Vent" on the right. The cursor is returned to "Signal" when
the ± key is first double- then single-tapped (the dot "•" indicates active
reverse mode).
The ENTER key at the centre of the control panel confirms the entered value
or activates the program selected at the cursor position.
The right C I/O key has two functions. Pressing it once cancels the current
menu option or an incorrectly entered value. Keeping it pressed switches OFF
the device after three seconds.
e-Mail: mgkg@woehler.com
Wöhler DC 100
1 cursor position
4
2 trend symbol
3 ± -key
5
4 toggle active
6
5 unit of measurement
7 6 ENTER
7 ON/OFF and CANCEL
PRO
http://www.woehler.com
PRO
. The
PRO
49