SFA Sanipump VX 50 Bedienungs- Und Installationsanleitung Seite 81

6 Commissioning/Start-up/Shutdown
The pump (set) is removed from the pipe and stored
ü All safety regulations are observed.
1. Clean the pump set.
2. Preserve the pump set.
3. Observe the instructions given in (ð Section 3.3, Page 60) .
6.4 Returning to service
For returning the pump set to service, observe the instructions on commissioning/
start-up. (ð Section 6.1, Page 76)
Refer to and comply with the operating limits. (ð Section 6.2, Page 77)
For returning the pump set to service after storage also follow the instructions for
maintenance/inspection.
WARNING
Failure to re-install or re-activate protective devices
Risk of injury from moving parts or escaping fluid!
▷ As soon as the work is completed, properly re-install and re-activate any safety-
relevant devices and protective devices.
NOTE
On pumps/pump sets older than 5 years we recommend replacing all elastomer
seals.
Sanipump VX 50
79 of 331