Inhaltsverzeichnis
Werbung
IO-Link Data Dictionary
21.10.01.00065/02
Process Data Out
Vacuum
Blow-off
Vacuum with forced control
CM Autoset
PD Out Byte 0
EPC-Select
Profile-Set
PD Out Byte 1
Input pressure
ISDU Parameters
(all ISDUs use subindex 0 only)
ISDU Index
Display
Appearance
dec
hex
Identification
Vendor name
16
0x0010
17
0x0011
Vendor text
J. Schmalz GmbH
Name
Bits
0
1
2
3
5..4
7..6
7...0
Parameter
Data width
15 bytes
15 bytes
Access
Availability
wo
IO-Link V1.1, V1.0
wo
IO-Link V1.1, V1.0
wo
IO-Link V1.1, V1.0
wo
IO-Link V1.1, V1.0
wo
IO-Link V1.1 only
wo
IO-Link V1.1, V1.0
wo
IO-Link V1.1 only
Value range
Access
Default value
ro
J. Schmalz GmbH
ro
www.schmalz.com
2 of 11
SCPSi series
J. Schmalz GmbH
Aacher Straße 29, D 72293 Glatten
Tel.: +49(0)7443/2403-0
Fax: +49(0)7443/2403-259
info@schmalz.de
Remark
Vacuum on/off
Activate Blow-off
Vacuum on/off with continuous suction disabled
(regardless of dCS parameter)
Perform CM Autoset function and save EPC data in buffer
Select the function of EPC values 1 and 2 in PD In
(content is 2 bit binary coded integer)
0:
EPC value 1 = Input pressure (0.1 bar)
EPC value 2 = System vacuum (1 mbar)
1:
EPC value 1 = CM-Warnings (see ISDU 146 for bit definitions)
EPC value 2 = Evacuation time t1 (1 msec)
2:
EPC value 1 = Leakage of last suction cycle (1 mbar/sec)
EPC value 2 = Last measured free-flow vacuum (1 mbar)
3:
EPC value 1 = Primary supply voltage (0.1 Volt)
EPC value 2 = Air consumption of last suction cycle (0.1 NL)
Select Production Profile
(content is 2-bit binary coded integer)
0: Activate Production Setup Profile P0
1: Activate Production Setup Profile P1
2: Activate Production Setup Profile P2
3: Activate Production Setup Profile P3
Pressure value from external sensor (unit: 0.1 bar)
Remark
Manufacturer designation
Internet address
29.08.2014
SCPSi Data Dictionary
Werbung
Inhaltsverzeichnis
