Short-Time Centrifugation; Acoustic Signal - Hettich EBA 270 Bedienungsanleitung

14.3

Short-time centrifugation

•
Set the desired speed with the keys
•
Keep the key pressed. The rotation indicator
PULSE
from 0.
The first minute is counted up in seconds, and then the time is displayed in minutes.
When the time is displayed in minutes, a point flashes next to the number.
•
Release the key again to end the centrifugation run. The rotor runs down with the set brake step.
PULSE
During the centrifugation run the rotor speed and the expired time are displayed.
15

Acoustic signal

The acoustic signal sounds:
•
After a disturbance occurs, in 2 second intervals.
•
After completion of a centrifugation run and rotor standstill in 30 second intervals.
The acoustic signal is stopped by opening the lid or pressing any key.
The acoustical signal can be activated or deactivated as follows when the rotor is at a standstill:
•
Switch off the mains switch.
•
Keep the key beneath the speed indicator and the key
•
Switch on the mains switch and release the keys again.
•
Press the key beneath the speed indicator until the following display appears:
RPM x 100 t
The acoustical signal setting is displayed on the time display.
0 = acoustical signal deactivated, 1 = acoustical signal activated.
•
With the keys below the time display, set 0 or 1.
•
Press the key to save the setting.
STOP
AB2300DEENFRIT
beneath the speed indicator.
appears while the rotor is turning. The time count starts
PULSE START
OPEN STOP
Rev. 11 / 12.2022
pressed simultaneously.
PULSE
EN
41/85