Safety Guidelines - Guntermann & Drunck HardBoot plus Installation Und Bedienung

Safety guidelines

Safety guidelines
Please read the following safety guidelines attentively before you start running the
G&D product. The guidelines help to avoid damage to the product and prevent pos-
sible violations.
Inform all persons that use this equipment in detail about these safety guidelines.
Observe all warnings or operating instructions put on the device or stated in this
operating guide.
, Check that the power cords, plugs and sockets are in good condition.
, The HardBoot devices can only be connected to three-wire 230 VAC (50-60 Hz)
sockets.
, Always plug the the HardBoot devices into properly grounded power sockets
(two poles plus ground).
, The power outlets of the HardBoot devices are not circuit breakers! If you want to
intervene on equipments connected to the HardBoot devices you must disconnect
these equipments from the HardBoot devices.
, The HardBoot devices are designed to be installed on a dedicated circuit that
must have a circuit breaker or fuse protection.
, Do not attempt to disassemble the HardBoot devices, they contain potentially
hazardous voltages.
! Never exceed 10 amp total load for each group of 4 (four) power outlets of the
HardBoot plus or the HardBoot CCX.
! The electrical power sockets used to plug the power cords of the HardBoot
devices must be close to the devices and easily accessible.
! The HardBoot devices are intended for indorr use only. Do not install them in an
area where excessive moisture or heat is present.
! Always disconnect the 2 (two) power cords of both the HardBoot plus and the
HardBootCCX if you want to intervene on the HardBoot devices or on the equip-
ment powered from the the HardBoot devices.
! The HardBoot devices contain no user servicable parts and repairs are to be per-
formed by factory trained service personnel only.
! Always use shielded twisted pair cable for the ethernet connection.
1 · G&D HardBoot plus