Mie 8-00, Mie 16-00 And Mie 32-00 (Dvb-T) - axing MIE 8-00 Betriebsanleitung

Operation instructions | MIE 8-00 | MIE 16-00 | MIE 32-00 | MIE 4-02 | MIE 8-02 | MIE 3-02 | MIE 6-02
3.5.2.

MIE 8-00, MIE 16-00 and MIE 32-00 (DVB-T)

 Click on PHASE 3, to modify the setting of the modulators.
Configuration of the modulators
Select a
modulator
 Select a modulator from MODULATOR 1 to MODULATOR 6 on the left.
 Make the required changes.
 Click SAVE for each modulator.
Only then the changes will be saved, otherwise the changes will be lost.
Parameters:
Common Output Level
Norm
Output Channel
Page 36 of 68
The Common Output Level option include a general attenuation of all modulator outputs. The
highest output level is reached with a setting of 20 dB, the lowest level with a setting of 0 dB.
In this selection field, you can set the norm for the output channel spacing.
Note: Changing the norm works now according to following rules:
•
CCIR-->Australia : all modulators forced to 7MHz
•
Australia-->CCIR : all modulators forced to 8MHz, however with following exception: low
channels S2-S20 are 7MHz only, so those remain in 7MHz
Each of the modulators can be set to any output channel. No output channel may be selected
more than once!
BA_MIE.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2022-05-31