Duplicating A Program - axing MIE 8-00 Betriebsanleitung

Operation instructions | MIE 8-00 | MIE 16-00 | MIE 32-00 | MIE 4-02 | MIE 8-02 | MIE 3-02 | MIE 6-02
Re-mapping PIDs by hand
If packets should get a very specific OUT PID, this can be entered manually.
 Click in the OUT PID column of the program.
 Enter the PID with the keyboard or increase/decrease the PID with the arrow keys.
 Click on the green check mark.
This will complete the entry first.
 Click SAVE CHANGES.
The entered PIDs are saved in the headend.
3.4.6.

Duplicating a program

Programs can be duplicated in phase 2. This allows, for example, to offer a program in two different languages at the output (arte
DE/arte FR).
 Click on the program to be duplicated.
The table with the program information and contents opens.
 Click on Add.
The program is duplicated 1:1. It has the same name and the same input stream ID. It is not yet assigned to any modulator.
 Assign the duplicated program to a different modulator than the modulator of the original program. The original and
duplicated programs can now be configured differently.
Page 28 of 68 BA_MIE.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2022-05-31