axing MIE 8-00 Betriebsanleitung Seite 102

Operation instructions | MIE 8-00 | MIE 16-00 | MIE 32-00 | MIE 4-02 | MIE 8-02 | MIE 3-02 | MIE 6-02
 Then click on the green check mark.
The changes are accepted.
 To delete, click on the trashcan icon to the right of the line.
The line is deleted.
 Click SAVE.
This changes the entries in the headend.
Add custom descriptors to NIT
 Click in PHASE 2 on ADVANCED OPTIONS.
A dialog with options will open.
 Under Add NIT network descriptor (s) (HEX) add Descriptor(s) in hexadecimal format and bytes separated by space.
In the example below, a custom linkage descriptor is added to the NIT.
Note: The MIE validates only the descriptor length. Incorrect entries, e.g. those that do not correspond to the DVB standard, can
possibly lead to disturbances in the network.
 Click SAVE after you have finished entering your data.
This saves the entries in the headend.
Page 32 of 68 BA_MIE.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2022-05-31