Purging The Carburettor; Maintenance Of The Exhaust Pipe And Spark Catcher; Spare Parts Available For Purchase If Required - HERON 8896351 Bersetzung Der Ursprünglichen Bedienungsanleitung

PURGING THE CARBURETTOR

(FIG. 18)
1. Use the fuel valve to close the petrol supply by set-
ting the lever to the "OFF" position.
2. Place an appropriate container underneath the
drain bolt of the carburettor and then screw out
the drain bolt of the carburettor and drain the
dirty material into the prepared container.
•
ATTENTION
y Petrol will start flowing out of the loosened screw.
Purge the carburettor ideally outdoors since pet-
rol fumes are damaging to health. Likewise, use
appropriate protective gloves to prevent the skin
from being sprayed with petrol. Petrol is absorbed
through the skin into the body! Purge the carbu-
rettor away from any sources of flames and do not
smoke.
3. To purge the carburettor, open the fuel supply
using the fuel valve for a while to allow any dirty
material to flow out into a container. Then close
the fuel supply again by closing the fuel valve.
4. Then screw the carburettor drain screw with the
gasket washer back in and tighten firmly. After
opening the fuel valve, check that no fuel is lea-
king around the bolt.
If fuel does leak, tighten the mud bolt, or if neces-
sary replace the seal washer of the bolt.
y Hand the petrol with the dirty material from the carbu-
rettor in an enclosed container to a hazardous waste
collection facility.
•
ATTENTION
y The user can perform the carburettor purging operation
using the carburettor mud bolt themselves, however,
any work on the carburettor may only be performed by
an authorised service centre for the Heron® brand.
y The air-fuel ratio and the carburettor are set by the
manufacturer and it is not permitted to make any chan-
ges to these settings. Any amateur tampering with the
carburettor settings may result in serious damage to the
engine.
95
MAINTENANCE OF THE EXHAUST
PIPE AND SPARK CATCHER
 Leave the de-carbonisation of the exhaust and clea-
ning of the spark catcher to an authorised service cen-
tre for the HERON® brand.
SPARE PARTS AVAILABLE
FOR PURCHASE IF REQUIRED
Name
Spray gun set
without hose)
Pressure hose 10 m
Air filter
Starting set
Part no.
8896351A
8896351B
8896351C
8896351E
Table 3
EN