Technical Specifications - HERON 8896351 Bersetzung Der Ursprünglichen Bedienungsanleitung

II. Technical specifications
Model number/part number
HIGH-PRESSURE WASHER
Water connection requirements (clean water supply)
Supply water pressure range
Minimum water supply flow rate
Min. and max. water temperature
Water supply hose connection method
Self-draw water from a container function
Gasket seal with strainer in water connection
Pressurised water outflow parameters
Max. water pressure at the outlet
Water flow rate at the outlet
Water spray angle
PRESSURE HOSE 1)
Length of pressure hose
Max. water temperature and pressure for hose
SPRAY GUN 1)
Max. water flow rate:
Max. water temperature and pressure
ENGINE OF THE PRESSURE WASHER
Type of engine
Fuel type
Oil type for engine crankcase
Oil volume for engine crankcase
Cooling
Starting
Nominal/Max. engine power
Cylinder displacement
Spark plug
Fuel tank capacity
Operating time per full tank (3.6 l)
Sensor detecting the low oil level in the engine
Air filter
EN
8896351
Min. 1.4 bar – Max. 7 bar (140 – 700 kPa)
8.5 L/min
Min. ≥ 2 °C (without ice); Max. 50 °C
Brass hose adapter G¾" × 20 mm;
seal the threaded connection using
Teflon tape or Teflon thread (not hemp)
NO
¾" Gasket seal with strainer intended
for water tap cap nuts
186 bar (18.6 MPa)
7.9 L/min (nominal)
8.3 L/min (maximum)
0° (water beam)
15°; 25°; 40° fan - based on used nozzle
and a low-pressure shampoo nozzle (SOAP)
10 m
60°C; 22.0 MPa (220 bar)
25 L/min
60°C; 24.8 MPa (248 bar)
spark-ignited (petrol-powered), four-stroke,
single-cylinder with OHV valve gear
Lead-free 95 or 98 (Natural) without oil
motor SAE 15W40
approx. 440 ml
air-cooled
manual - using a pull starter
Rated 3.4 kW/Max. 3.8 kW/3600 min
3
196 cm
LG F7RTC or its equivalent
3.6 l
2 h with non-stop load (spraying)
YES
folded paper type
with PU foam pre-filter
Part no. 8896351C
-1
Table 1
82