HBM C16i Montageanleitung Seite 13

CAUTION
Grease load introduction
parts and dowel pin
S Fix the lower load introduction parts with a spanning washer when using
EPO3/50t or eccentric washers when using C16/EPU44A or C16/ZOU44A.
For subsequent sealing of the flexible tube, mount the tube clip supplied
with the load cell around the lower compression pad.
S Now insert the load cells by rotating them into the lower load introduction
part such that the dowel pin engages into the rotation stop recess.
S Now let down the weighbridge carefully such that there is just no load on
the load cells and that they can be aligned perpendicularly. At the same
time, introduce the load cells' upper load introduction parts into the upper
load carrying element. For this purpose, you can move the lower load
introduction element with the eccentric washers loosened. We recommend
that you use an appropriate prism level to check the load cell's
perpendicular mounting position by holding it against the cylindrical housing
tube. Then let down the bridge and proceed in the same way for the other
face.
C16i
A05516_01_Y00_01 HBM: public
Mounting
11