Fitting The Lever; One-Piece Lever (Nominal (Rated) Torque 100 N@M) - HBM TTS Montageanleitung

Fig. 5.2 Fitting the square adapter on the measuring head
Position the square adapter in accordance with the arrow markings (see
Fig. 5.1) on the measuring head; insert the knurled screw into the central hole
in the measuring head and screw the square adapter in tight.
Information
By keeping to the same angular position, any symmetry deviation will not affect
the reproducibility of the measurement results.
5.2

Fitting the lever

Depending on the nominal (rated) torque, there are one, two or three parts to
the lever. To make assembly easier, apply a little oil to the mating surfaces of
the individual components.
5.2.1 One‐piece lever (nominal (rated) torque 100 N@m)
S Press down the spring bolts of the lever.
S Push the lever as far as it will go into the receiving hole in the measuring
head.
S Turn the lever from side to side until you hear the spring bolts engage.
TTS
Knurled screw
Measuring
head
A01571_04_Y00_00 HBM: public
Assembling the torque wrench
Square adapter
11