VOLTCRAFT VC292 Bedienungsanleitung Seite 98

Insert/replace the batteries on the CLA60 clamp transformer:
1
The clamp transformer requires two 1.5 V micro batteries (e.g. AAA, LR3). On initial
operation or if the operating light on the slide switch flashes or no longer lights up,
insert two new, fully charged batteries.
1. Disconnect the measurement adapter from the measured object and the con-
nected test leads from your multimeter.
2. Switch the adapter OFF.
3. Open the battery compartment on the rear with a suitable screwdriver and re-
move the battery compartment cover.
4. Replace the used batteries with new ones of the same type. Insert the new bat-
teries into the battery compartment with the correct polarity. Look for the polarity
signs in the battery compartment.
5. Carefully replace the battery/fuse compartment cover.
98