Lengthening The Cutting Lines; Operation; Switching On And Off - FLORABEST FRT 550 A1 Originalbetriebsanleitung

GB IE NI
through the opening in the upper
handle (1) and around the the cable
strain relief (3).
3. Pull back the extension cable to
fasten.

Lengthening the cutting lines

The machine features an auto feeding
dual line ends system. The dual line ends
will automatically elongate every time you
switch on the machine.
To support proper line elongation, make
sure that the cutting head with line spool (11)
has stopped completely before switching on
the machine again.
The line cutter (19) will cut the longer lines
with audible sound to defined cutting circle
(29cm).
Regularly check the lines for damage
and verify the correct length.
• If no line remains visible, follow
L
the below steps:
i. Disconnect the plug from the
mains socket before the change.
ii. Change the line spool (See
"Cleaning and maintenance").
• Manually adjust the line length:
A
i. Disconnect the plug from the
mains socket.
ii. Briefly press and release the
manual line feed button (20).
Pull out both line ends. Repeat if
necessary.
108

Operation

WARNING: Danger of injury!
Never use the trimmer
without its protective cover
(10). Always check the
operability of the trimmer
before it is used. Check that
the mains voltage is the same
as indicated on the rating
plate. Always wear goggles
when working with the
trimmer.
Please observe local regulations
concerning noise protection.

Switching ON and OFF

1. Connect the trimmer to the mains socket
by extension cable.
2. Ensure a safe stance and hold the
equipment firmly with both hands. Do not
deposit the cutting head with line spool
(11) on the ground.
3. To switch on depress the ON / OFF
switch (2). Release the ON / OFF switch
(2) to switch off.
After the trimmer has been switched
off the cutting head will continue
to rotate for a few seconds. Keep
hands and feet well away. There is
the danger of cutting damage. Risk
of injury from cuts.
The ON / OFF switch must
not be locked in place. The
trimmer must not be used if
the switch is damaged. There
is the immediate danger of
injury if the motor does not
switch off after the ON / OFF
switch has been released.