Switching The Laser On And Off; Set Rotational Speed; Tips And Tricks; Maintenance And Cleaning - Parkside PHKS 1350 C2 Originalbetriebsanleitung

Switching the laser on and off

Switching on
♦ Press the ON/OFF switch laser
Switching off
♦ Press the ON/OFF switch laser
NOTE
► If the batteries are spent, replace them with
two new 1 .5 V alkaline button cells (type
AG 13/LR 44, e .g . GPA 76) .

Set rotational speed

■ Turn the adjusting wheel
rotational speed (arrow marking ▲)
(1 = lowest rotational speed/
6 = highest rotational speed):
Use the following suggested settings or set the
rotational speed on the adjusting wheel
required .
Material
Cross cuts & longitudinal cuts in
hard and soft wood (solid wood)
Chipboard, fibre board
Core board, plywood
Coated and veneered boards
PVC sheets
Acrylic glass sheets, perspex
Aluminium plate
Aluminium profile
Plaster board
Stone wool board
Cement-bonded particle board
PHKS 1350 C2
.
.
to the desired
as
Rotational
speed
setting
6
6
6
6
3 – 5
2 – 4
4 – 6
4 – 6
1 – 2
1 – 2
1 – 2

Tips and tricks

■ Avoid damaging the cutting edge of sensitive
materials, e .g . coated chipboards or doors, by
sticking masking tape along the cutting line .
Another benefit of this is that it is easier to mark
a line on the tape than on a shiny surface . An
even more effective method of protecting the
cutting edges is to clamp a thin piece of wood
along the cutting line (this wood is also sawn) .

Maintenance and Cleaning

WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work.
■ The appliance must always be kept clean, dry
and free from oil or grease .
■ To clean the casing, use a soft dry cloth .
■ The blade guard must always move freely and
close automatically . Therefore, keep the area
around the blade guard clean at all times .
Remove dust and chips by blowing them out
with compressed air or with a brush .
WARNING!
■ If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or his representative in order to avoid safety
hazards .
GB │ IE │ NI │ CY │ 11 ■