Bluetooth Device Playback; Pairing; Usable Controls; Playback From A Bluetooth Device - Teac CD-P750 DAB Bedienungsanleitung

5 – Bluetooth device playback
This unit can output sound from a computer, portable audio
device or other equipment that supports Bluetooth wireless trans-
mission (A2DP). Moreover, if the Bluetooth device supports AVRCP,
the PLAY (7) button and other controls on this unit can be used
to control playback on the Bluetooth device.

Pairing

Follow the procedures below to enable communication with a
Bluetooth device.
NOTE
Pairing also requires operation of the Bluetooth device.
Refer to the operation manual of the Bluetooth device for
procedures.
1.
Select BLUETOOTH as the current source. (see "Selecting the
playback source" on page 19)
2.
Press and hold the main unit BACK [PAIRING] button or
remote control DISPLAY/RDS/INFO [PAIRING] button.
A PAIRING message will blink on the display.
BLUETOOTH
PAIRING
3.
Enable Bluetooth transmission on the other Bluetooth device.
4.
On the other Bluetooth device, select this device "CDP750_XXXX"
("XXXX" is a unique 4-digit hexadecimal identifier for the unit).
When pairing succeeds, this unit and that device will be con-
nected and Connected will appear on the Home Screen.
BLUETOOTH
Connected
NOTE
i Some older Bluetooth devices require the input of a passkey.
Enter 0000 in such cases.
i Pairing will automatically end if connection is not confirmed
within two minutes.
i When this unit is turned on, it will automatically try to connect
with the Bluetooth device to which it was previously con-
nected. At this time, pairing will automatically end after five
minutes if connection is not possible because that Bluetooth
device is not turned on or its Bluetooth function is turned off.
30

Usable controls

Controls on the main unit and included wireless remote control
(RC-1336) can be used to control the connected Bluetooth device
if it supports AVRCP.
Main unit Remote control
PLAY (7) button
7 button
PAUSE (9) button
9 button
STOP (8) button
8 button
MULTI JOG dial
.// [l/;]
turning buttons
m/, [FAST]
m/, buttons
buttons
ATTENTION
Operation might not occur properly depending on the con-
nected Bluetooth device.

Playback from a Bluetooth device.

After pairing with the other Bluetooth device in advance, follow
the procedures below for playback from it.
1.
Select BLUETOOTH as the current source. (see "Selecting the
playback source" on page 19)
2.
On the other Bluetooth device, select this device "CDP750_XXXX"
("XXXX" is a unique 4-digit hexadecimal identifier for the unit) to
connect them.
Connected appears on the Home Screen when connection
completes.
Controls on the main unit and included wireless remote control
(RC-1336) can be used to control the connected Bluetooth device,
and this unit can output the playback sound from the Bluetooth
device.

Unpairing

The Bluetooth device that is currently connected can be unpaired
from the unit.
1.
Select BLUETOOTH as the current source. (see "Selecting the
playback source" on page 19)
2.
Press the main unit BACK [PAIRING] button or remote con-
trol DISPLAY/RDS/INFO [PAIRING] button.
A Disconnect? message will appear on the display.
BLUETOOTH
Disconnect?
3.
Press the main unit MULTI JOG dial or remote control ENTER
button to unpair the device.
Press the main unit BACK [PAIRING] button or remote con-
trol CLEAR button to cancel unpairing.
4.
After unpairing, the pairing operation will start.
Function
Play
Pause
Stop
Selects tracks
Search backward
and forward