Important Notes; Notes On Operating Instructions; Intended Use - Mettler Toledo InPro 5000 Bedienungsanleitung

52002465_F_IM_InPro5000i_edf_2022_09.qxp_52002465_F_IM_InPro5000_edf_2022
6
2

Important notes

Notes on operating instructions

2.1
These operating instructions contain all the
information needed for safe and proper use of
the InPro 5000 (i) sensor.
The operating instructions are intended for personnel
entrusted with the operation and maintenance of the
sensors. It is assumed that these persons are familiar
with the equipment in which the sensor is installed.
Warning notices and symbols
This instruction manual identifies safety instructions
and additional information by means of the following
symbols:
This symbol draws attention to safety instructions
and warnings of potential danger which, if neglected,
could result in injury to persons and / or damage
to property.
This symbol identifies additional information and
instructions which, if neglected, could lead to defects,
inefficient operation and possible loss of production.
2.2

Intended use

InPro 5000 (i) sensors are intended solely for in
line measurement of dissolved CO
ide), as described in this instruction manual.
Any other use, or use not mentioned here, that is in-
compatible with the technical specifications is deemed
inappropriate. The operator is solely responsible for
any damage arising from such use.
Other prerequisites for appropriate use include:
– observing the instructions, notes and requirements
set out in this instruction manual.
– observing all local safety regulations concerning
safety on work.
– observing all information and warnings in the
documentation dealing with the products used
togeth er with the sensor (housings, transmitters,
etc.).
– observing all safety regulations governing
the equipment in which the sensor is installed.
– observing the prescribed inspection and mainte-
nance intervals.
– correct care and maintenance of the unit,
according to the instruction manual.
– observing the prescribed environmental and
operational conditions, and permitted installation
positions.
InPro 5000 (i)
52 002 465 F
InPro 5000 (i) CO
2
2
© 09 / 2022 METTLER TOLEDO
Printed in Switzerland
Sensor 12 mm
(carbon diox-