Setting The End Of The Cooking Time; Timer - hanseatic HBO7213PA1 Gebrauchsanleitung

3. Set the desired cooking time using the
sensors and or the slider.
After a short time, the cooking duration will
light up permanently.
4. Start the oven's operation with the sensor
.
Once the preset cooking duration has
elapsed, you will hear 5 signal tones and
the display will show '
switch into standby mode.
The cooking time can be changed at any
time. The change will take effect approx.
6 seconds after the last sensor operation.
To end the cooking process early, switch the
oven off with the sensor
Setting the end of the cooking
time
If you want your cooked food to be ready at
a certain time, you must set the end of the
cooking time and the cooking duration.
Requirements:
– The time is set correctly.
– You have set the cooking time (see the pre-
vious section, steps 1 to 3.).
1. Tap the sensor.
The symbol will appear on the display
and the hour display will flash.
2. Tap the sensor or swipe over the slid-
er to set the number of hours.
'. The oven will
End
.
Operating the oven
3. To switch to the minute display, tap the
symbol .
4. Tap the sensor or swipe over the slid-
er to set the number of minutes.
5. To save the set cooking time, tap the sen-
sor again .
The display shows the selected function,
set temperature, (remaining) cooking time
and the symbol .
6. Tap the sensor.
The oven will switch on at the calculated
time and will switch into standby mode at
the end of the cooking time. You will hear 5
signal tones and the display will show '
To end the cooking process early, switch
the oven off with the sensor

Timer

Your oven is also equipped with a timer. You
set a specific period, just as you would with an
egg timer. Once the period has expired, a tone
sounds. You can set a duration of one minute
up to 23:59 hours.
Please note that the countdown timer does
not switch the oven on or off. You can also
use the countdown timer when the oven is
not switched on.
1. Briefly tap the sensor
The symbol will appear on the display
and the hour display will flash.
2. Tap the sensor or swipe over the slid-
er to set the number of hours.
Page EN-17
'.
End
.
.