Herunterladen Inhalt Inhalt Diese Seite drucken

The Timer; Overview; Setting The Current Time; Kitchen Timer - hanseatic 5022CE3.313eEHiTaDW Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

The timer

Overview

OK
Button for mode selection
>
Plus button
<
Minus button
Symbol for operating status
Symbol for the timer
Symbol for the operating time

Setting the current time

After connecting to the mains supply or after
switching the appliance back on after a power
failure, the digits
will flash on the display.
0. 0 0
• Press and hold the OK button (or the
< / > buttons at the same time) until the
symbol appears on the display and the
dot below the symbol flashes.
• Use the < / > buttons to set the current
time within 7 seconds.
Approx. 7 seconds after the time is set, the
new information is saved and the dot below
the
symbol stops flashing.
You can correct the time later by pressing the
< / > buttons at the same time. The current
time can be corrected while the dot under the
symbol is flashing.
The oven can be switched on only if the
symbol is shown on the display.
The timer

Kitchen timer

You can active the Kitchen Timer at any time,
regardless of the status of other functions.
The Kitchen Timer can be set from 1 minute
up to 23 hours and 59 minutes.
To set the Kitchen timer:
1. Press OK, then the display will show
blinking
symbol.
2. Use the < and > buttons to set the Kitch-
en Timer.
The display will show the set time and
Kitchen Timer symbol. Once the set time
elapses, alarm sounds and the
flashes.
3. Press and hold OK button or simultane-
ously press and hold the < and > button
to mute the alarm.
The symbol will be off and the display will
show the current time.
If no button is pressed, alarm will turn
off automatically after approximately
7 minutes.

Timed operation

To set the appliance to switch off after a spe-
cific duration:
1. Set the function selector switch (12) and
the temperature switch (14) to the desired
positions.
2. Press OK repeatedly until the display
shows
(duration) briefly and the
dur
symbol will be flashing.
3. Use the < / > buttons to set the desired
duration from 1 minute to 10 hours.
The set duration will be memorised after
about 7 seconds. The display will show the
current time and the
After the set time has elapsed, the oven
automatically turns off, an acoustic signal
sounds and the
symbol starts flashing.
4. Turn the function switch (12) and temper-
ature switch (14) of the oven to 'Off'.
Page EN-23
symbol
symbol.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

5022ce3.313eehitadjxv3637461238865608

Inhaltsverzeichnis