Starting, Interrupting And Ending The Oven's Operation; Quick Pre-Heating; Setting The Cooking Time - hanseatic HBO7213PA1 Gebrauchsanleitung

Page EN-16 Operating the oven
Starting, interrupting and
ending the oven's operation
You have selected the function and set the
temperature. In order to
• start/continue the operation, tap the sen-
sor .
The lighting will switch on; the oven will
heat up. During the heating process, the
temperature display will flash. Up to eight
bars below the temperature display show
the progress of the heating process.
• interrupt the operation, tap the sensor
again .
The temperature display stops flashing and
the operation is paused.
• turn off the oven early, tap the
The oven is now in stand-by mode.
The function and temperature can be
changed at any point during the cooking
process. The change will take effect approx.
6 seconds after the last sensor operation.
If the door is opened during the function oper-
ation, the operation will be paused.

Quick pre-heating

The oven offers this additional function in or-
der to speed up the pre-heating process (ex-
ceptions: Functions
• Select a function and a temperature, as
described above, and tap the sensor
The pre-heating symbol will also appear
in the display. The oven will begin to heat.
Once the pre-set temperature has been
reached, you will hear a signal tone.

Setting the cooking time

sensor.
You can select a cooking time of up to 9 hours.
The cooking time can be set in the range of
– up to 30 minutes in 1 minute steps.
– from 30 minutes in 5 minute steps.
1. Select a function and a temperature, as
described above.
2. Tap the
On the left, next to the temperature, the
display will flash '
, , ).
sensor.
hr'.
00:00
.