Options; Stabilized Power Supply; Dc-Dc Converter - HBM ME50S6 Bedienungsanleitung

Options

7 Options
7.1

Stabilized Power Supply

The module KM001 can be used to connect the measuring amplifier to a sym­
metrical supply voltage "15.6...25.0 V. When installing the module KM001,
attention must be paid to the marking. The jumpers BR3 and BR4 have to be
configured according to the table below.
Pin assignment:
positive pole . . . . . . . . . . . . . . . .
negative pole . . . . . . . . . . . . . . .
supply zero . . . . . . . . . . . . . . . . .
7.2 DC‐DC Converter
The manufacturer can mount a DC‐DC converter onto the board for the opera­
tion of a simple operating voltage with simultaneous electrical isolation between
operating voltage and measuring circuit. The voltage converter can be deliv­
ered for operation +9...+35 V (for unstabilized voltage).
Pin assignment:
positive pole . . . . . . . . . . . . . . . .
negative pole . . . . . . . . . . . . . . .
When using the modules KM001 resp. a DC‐DC converter attention has to be
paid to the jumpers BR3 and BR4 which are re‐configured.
factory settings:
With module KM001 resp. DC‐DC converter
18
pin 15a
pin 16a
pin 19c
pin 4a
pin 5a
A00260_04_Y00_01 HBM: public
1 2
I
BR3
I
BR4
1 2
BR3
BR4
3
3
I
I
ME50S6