HBM ME50S6 Bedienungsanleitung Seite 7

Maintenance and cleaning
The Clip Electronic are maintenance‐free. Please note the following points
when cleaning the front panel:
S Remove the mains plug from the socket before cleaning.
S Clean the front panel with a soft, slightly damp (not wet!) cloth. Never use
solvents, since they may damage the labelling on the front panel.
S When cleaning, please ensure that no liquid finds its way into the device or
onto the contacts.
Residual dangers
The ME50S6 scope of performance and supply covers part of the measuring‐
technology, only. The plant designer/constructor/operator must in addition de­
sign, realise and take responsibility for the measuring‐system's safety such
that potential residual dangers are minimized. The respective regulations must
in any case be observed. Residual dangers regarding the measuring system
must be specified explicitly.
Reconstruction and modifications
HBM's express consent is required for modifications regarding the ME10
construction and safety. HBM does not take responsibility for damage resulting
from unauthorized modifications.
In particular, repair and soldering works on the boards are prohibited. If com­
plete componentry is replaced use original HBM components, only.
Qualified personnel
The device may be used by qualified personnel, only; the technical data and
the special safety regulations must in any case be observed. When using the
device, the legal and safety regulations for the respective application must also
be observed. The same applies if accessories are used.
Qualified personnel means: personnel familiar with the installation, mounting,
start‐up and operation of the product, and trained according to their job.
Maintenance and repair work on an open device with the power on should only
be undertaken by trained personnel who are aware of the above‐mentioned
dangers.
ME50S6
A00260_04_Y00_01 HBM: public
Safety instructions
5