Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Unpacking the appliance (02, 03)
■
Only handle petrol out of doors and never
in enclosed spaces.
■
It is essential to heed the code of conduct
stated below.
■
Only transport and store petrol and oil in con-
tainers approved for that purpose. Ensure
that children have no access to stored petrol
and oil.
■
In order to avoid ground contamination (envi-
ronmental protection) when filling, ensure
that no petrol or oil enters the soil. Use a fun-
nel for filling.
■
Never fill the appliance in enclosed spaces.
Petrol vapours may gather at ground level,
and thereby result in a deflagration or even
an explosion.
■
Immediately wipe any spilled petrol off the
appliance and the ground. Allow textiles used
to wipe off petrol to dry in a well ventilated
place before disposing of them. Otherwise,
sudden self-ignition may occur.
■
If petrol has been spilled, petrol vapours oc-
cur. For this reason, do not start the engine
at the same location and move it at least 3 m
away.
■
Avoid skin contact with mineral oil products.
Do not inhale petrol vapours. When filling, al-
ways wear protective gloves. Change and
clean protective clothing regularly.
■
Ensure that your clothing does not come into
contact with petrol. If petrol has got onto your
clothing, change it immediately.
■
Never open the fuel tank cap while the en-
gine is running or hot.
■
Never fill the fuel tank while the engine is run-
ning or hot.
■
Never over-fill the fuel tank (petrol expands).
■
Always screw on the fuel tank cap tightly.
■
Replace a damaged fuel tank or fuel tank
cap.
■
Never eat, drink or smoke when filling the ap-
pliance with petrol or oil.
■
If petrol has leaked out:
■
Do not start the engine.
■
Avoid start attempts.
■
Pick up leaked petrol using a binding
agent or cloth and dispose of in the prop-
er manner.
■
Clean the appliance.
469186_f
■
If engine oil has leaked out:
■
Do not start the engine.
■
Pick up leaked oil using an oil binding
agent or cloth and dispose of in the prop-
er manner.
■
Clean the appliance.
4 UNPACKING THE APPLIANCE (02, 03)
WARNING! Danger of crushing if the ma-
chine tips over! The appliance is heavy! If it tips
over, limbs can be crushed and persons can be
seriously injured.
■
At least two persons are required for unpack-
ing the appliance!
■
Avoid tipping the appliance!
The appliance is supplied with all accessory parts
in a cardboard box. The box is located on a euro
pallet.
1. Place the box on a level horizontal surface.
2. Remove the packing straps.
3. Open the box at the top (02/a).
4. Remove the packaging material.
5. Carefully remove loose parts, bag with small
parts and operating instructions.
6. Use a knife to carefully cut open the rear wall
of the box (i.e. where the engine is located)
so that the appliance is not damaged.
7. Fold down the rear wall of the box (02/b).
8. Carefully remove the other loose parts and
other packaging material.
9. Roll the snow blower backwards, i.e. with the
engine at the front, out of the box (03/a).
5 ASSEMBLY
WARNING! Danger if assembly is not
carried out completely! Use of an incompletely
assembled device can result in serious injury.
■
Only use the device when it is fully assem-
bled!
■
Before switching on, check that all safety and
protective devices are in place and function-
ing correctly!
Necessary tools
No.
Tool
1
Open-end or ring spanner WAF 10 (x2)
2
Open-end or ring spanner WAF 13
33
Werbung
Inhaltsverzeichnis
