Starting The Engine - AL-KO Snow Line 560 II Betriebsanleitung

GB
If the skid plates are worn (sliding edge
( 24-1) worn through, turn 180° and use
the other side ( 24).
See the replacement parts list when ordering
replacements.
Checking the tyre pressure
and then at least once every three months during the
period of use.
The maximum allowed tyre pressure is indicated on
the tyres ( 20-1). Note: 1 bar = approximately 14.5
psi
Each time before starting, check to make sure that the
four shear pins ( 25-1) are intact.
Replace broken shear pins with original replacement
parts. Using unauthorised replacement parts may
cause severe damage to the machine! See the re-
placement parts list when ordering replacements.
Check all controls, safety devices, nuts, screws and
secured and in good condition, and and that no parts
are missing.
28

Starting the engine

Danger - risk of poisoning!
Never leave the engine running in an enclosed
space.
Position indicators:
Choke
CLOSE
OPEN
Gas
Fast Slow
Engine key
Off On
Fuel tap Closed
Open
Primer button
Starting procedure
1. Check the oil and fuel levels.
2. Open the fuel tap ( 27).
3. Set the choke to ON (
4. Press the primer button 3 times at 2-second
intervals( 28-1). In temperatures under 10 °C,
press the primer button 5 times.
5. Move the throttle to the Fast position (
6. Insert the engine key (
7. Pull the starter rope lightly until you feel resis-
tance, then pull out briskly and allow the rope to
return slowly ( 31).
Translation of original user instructions
AL-KO snow blower
27-1).
29).
30-1).